Connecting the supply voltage
The supply voltage must be within the operating range. Connect the supply voltage to power supply.
Protect the module by using a fuse with requisite fuse level: 2 amps. To avoid damage, switch off power
to the device when connecting/disconnecting the main connector to the device.
The CS100 and control system must be connected to the same power supply and ground connection to
ensure trouble free communication.
Polarity reversal
Polarity reversal can damage the unit. Protect the CS100 module against power supply polarity reversal
by using an external fuse, maximum 2 amps.
IP protection rating
IP 67 rating is ensured only with the following guidelines:
•
Do not expose the device to dust and water if the connectors are not plugged in.
•
Do not immerse the device in water or other liquids.
•
Do not operate the device unless temperature is between -40 °C and +75 °C (-40 °F and +167 °F).
•
Do not store and/or transport the device unless it is kept at a temperature between -40 °C and +85 °C
(-40 °F and +185 °F).
Welding guidelines
Welding should be done before the installation of the control system.
The following is recommended when welding on a machine equipped with electronic components:
•
Turn the engine off.
•
Remove electronic components from the machine before any arc welding.
•
Disconnect the negative battery cable from the battery.
•
Do not use electrical components to ground the welder.
•
Clamp the ground cable for the welder to the component that will be welded as close as possible to
the weld.
Warranty and liability
We assume no liability for defects caused by normal wear, external influences, and errors of installation,
operating or maintenance. This also applies if the customer itself or third parties without our approval
modify the components of our products (e.g. devices, elements or additional hardware facilities;
programs or program elements of the software).
Servicing the CS100
W
Warning
The device can only be repaired by the manufacturer, it is not field serviceable. Opening the device
housing will void the Warranty.
W
Warning
To prevent misuse, immediately inform Danfoss in case of loss or theft of the device or the related SIM
card that is factory pre-installed on it.
Technical Information
PLUS+1 Connect CS100 IoT Gateway — Professional Install Only
Safety information
12 |
©
Danfoss | October 2020
BC299456869228en-000101
