Danfoss Native BACnet VLT HVAC Drive, Руководство по эксплуатации, Страница: 23 / 31

6 Parameters
6.1 Parameter Overview
6.1.1 Parameter List
Parameter Default value Range
Conversion
index Data
type
8-01 Control Site Dig. and ctrl. word [0] [0 - 2] - 5
8-02 Control Source Option A [0 - 4] - 5
8-03 Control Timeout Time 1 s 0.1 - 18000 - 1 7
8-04 Control Timeout Function Off [0] [0 - 10] - 5
8-05 End-of-Timeout Function Hold set-up [0] [0 - 1] - 5
8-06 Reset Control Timeout Do not reset [0] [0 - 1] - 5
8-07 Diagnosis Trigger Disable [0] [0 - 3] - 5
8-10 Control Profile FC [0] [0 - x] - 5
8-30 Protocol FC
8-31 Address 1 [0 – 255]
8-32 Baud Rate 9600 [0 – 7]
8-33 Parity / Stop Bits No Parity, 1 Stop Bit
8-35 Minimum Response Delay 10mS
8-36 Maximum Response Delay 5000mS
8-37 Maximum Inter-Char Delay 25.00mS
8-50 Coasting Select Logic OR [3] [0 - 3] - 5
8-52 DC Brake Select Logic OR [3] [0 - 3] - 5
8-53 Start Select Logic OR [3] [0 - 3] - 5
8-54 Reversing Select Logic OR [3] [0 - 3] - 5
8-55 Set-up Select Logic OR [3] [0 - 3] - 5
8-56 Preset Reference Select Logic OR [3] [0 - 3] - 5
8-70 BACnet Device Instance 1 [1-4194304] -
8-72 MS/TP Max Masters 127 [1-127] -
8-73 MS/TP Max Info Frames
8-74 "I-Am" Service
Once at powerup [0] [0-1] -
8-75 Initialisation Password “admin” String[19]
Table 6.1 BACnet Specific Parameter List
Please refer to the
VLT ® HVAC Drive Drive Operating Instructions, MG.11.Ax.yy
for a comprehensive parameter list or to the
VLT ®
HVAC Drive Drive Programming Guide, MG.11.Cx.yy for detailed descriptions of parameters.
Conversion index
This number refers to a conversion figure used when writing or reading to and from the frequency converter.
Conv.
index 100 67 6 5 4 3 2 1 0 -1 -2 -3 -4 -5 -6
Conv.
factor 1 1/60 1000000 100000 10000 1000 100 10 1 0.1 0.01 0.001 0.0001 0.00001 0.000001
Parameters
VLT
®
HVAC Drive Native BACnet Operating Instructions
22 MG.14.C1.02 - VLT
®
is a registered Danfoss trademark
6 6