H1P Auxiliary mounting, option H5 (SAE B-B, 15 teeth)
Option H5, ISO 3019-1, flange 101-2 (SAE B-B, 15 teeth)
Paint free
4x M12x1.75-6H THD
19.75 min THD depth
2x 146 ±0.35
2x 73 ±0.175
Note:
Bolt length greater than
19.75 mm could result in
a leak or damage to the unit
1.956 ±0.076
11.4 ±0.25
Mating shaft shoulder must
Not protrude beyond this point
Mating shaft must not
Protrude beyond this point
R0.8 max
∅
101.651
+0.076 0
∅
107.823
+0.13 0
Auxiliary mounting pad
For mating flange 101-2
Per ISO 3019-1 (SAE B)
O-ring seal required
Ref
∅
94.92 id x 2.62 cross section
14.5 min
Shaft clearance
57.2 min
Shaft clearance
Spline data
Number of teeth : 15
Pitch fraction
: 16/32
Pressure angle : 30°
Pitch
∅
:
∅
23.813
Type of fit
: fillet root side
Per
: ANSI B92.1b CLASS 7e
239.6 ±2.5
P700 33 321-45
Specifications
Option
H5
Spline
15 teeth, 16/32 pitch
Maximum torque
1)
405 N•m [3580 lbf•in]
1)
For definitions of maximum and rated torque values, refer to
Basic Information
11062168, section Shaft Torque
Ratings and Spline Lubrication.
C
Caution
Standard pad cover is installed only to retain coupling during shipping. Do not operate pump without an
auxiliary pump or running cover installed.
H1P displacement limiter, 045/053 Single, option B and D
2x displacement
limiter screw
Wrench size
4 internal hex
2x displacement
limiter seal nut
Wrench size
13 external hex
Torque to 23.0 nm
2x 74.4 ±0.8
2x 106.3 ±0.8
2x (116.1)
P700 33 194
Please contact Danfoss representative for specific installation drawings.
Technical Information
H1 Axial Piston Single Pumps, Size 045/053
Dimensions
©
Danfoss | May 2017
11063344 | BC00000059en-US1001 | 45
