Danfoss FC 302, Инструкция по эксплуатации

Страница: 27 / 77

FC 300 Instruction Manual
How to Install
"
Encoder Option MCB 102
The encoder module is used for interfacing feedback from motor or process. Parameter settings in group 17-xx
Used for:
• VVC plus closed-loop
• Flux Vector Speed control
• Flux Vector Torque control
• Permanent magnet motor with SinCos
feedback (Hiperface
® )
Incremental encoder: 5 V TTL type
SinCos Encoder: Stegmann/SICK
(Hiperface
® )
Selection of parameters in par. 17-1* and
par. 1-02
When the encoder option kit is ordered
separately, the kit includes:
• Encoder module MCB 102
• Enlarged LCP fixture and enlarged
terminal cover
The encoder option does not support
FC 302 adjustable frequency drives
manufactured before week 50/2004.
Min. software version: 2.03 (par. 15-43)
Installation of MCB 102:
•
The power to the adjustable frequency drive must be disconnected.
•
Remove the LCP, the terminal cover, and the cradle from the FC 30x.
•
Fit the MCB 102 option in slot B.
•
Connect the control cables and fasten the cables by the clamp to chassis.
•
Fit the enlarged LCP fixture and enlarged terminal cover.
•
Replace the LCP.
•
Connect the power to the adjustable frequency drive.
•
Select the encoder functions in par. 17-*.
•
See also description in chapter Introduction to FC 300 , section Speed PID Control
27
MG.33.A4.22 - VLT is a registered Danfoss trademark