Danfoss ET6300, Руководство оператора

Страница: 30 / 44

5.2.6 Steel type holder replacement
Positioning the steel type holders
1. Use the wrench (1) to push the locking pin in the stamp holder
(3) to the left and hold it.
2. Use the retaining bolt to insert the steel type holder (2) into the
mounting hole.
3. Remove the die wrench to release the pressure on the locking
bolt - the intermediate die is now fixed.
Removing the steel type holder
1. Hold the steel type holder with one hand.
2. Push the locking pin in the steel type holder (2) with the wrench
(1) in the other hand and hold it.
3. Remove the steel type holder.
4. Remove the wrench (1) to relief the pressure on the locking pin.