Danfoss ET5070, Руководство оператора, Страница: 50 / 96

9. Connect the cable (1) into the socket for the depth stop.
Adjusting the control unit:
1. Activate the illuminated foot pedal. The machine is closed
automatically when the workpiece is pressed against the depth
stop.
2. Form the workpiece.
3. Press the button to open the tool.
4. Check the workpiece.
5. If the workpiece meets the requirements: produce other identical
workpieces.
6. If the dimension is not reached: Adjust difference on the control
unit, form again and check the workpiece.
Activate automatic opening in the control for series production.
5.6 Setting the forming dimension
The forming dimension (X) must be set specifically for the workpiece.
1. Read the forming dimension in the forming dimension table of
the system supplier, e.g. Ø 17.4 mm.
2. Select crimping dies with a smaller or the same diameter, e.g.
Ø 17 mm,
3. Place the crimping dies in the tool.
4. Set the control and/or micrometer to the requested dimension:
Control system: Forming dimension diameter