![background image](http://html1.mh-extra.com/html/danfoss/et4400/et4400_operators-manual_3412392039.webp)
5.3.3 Remote automatic mode, via dual foot switch
WARNING!
Risk of squeezing!
When the die system closes, there is a risk of getting squeezed
between the die and the workpiece.
• Keep the feed opening for the workpiece as small as possi-
ble.
• Keep a minimum distance of 120 mm (A) to the die system.
1.
Move the operation selector switch to >Operation via foot
switch< in order to activate the double foot switch.
2.
Manually position the pre-mounted work piece in the tool.
3.
Hold the work piece with one hand during the forming process.
4.
Activate and hold the double foot switch.
5.
When the forming process is completed, release the foot switch
>Close< and activate the foot switch >Open< to open the tool.
6.
Remove the work piece from the tool.
7.
Check the forming dimension after the first forming process.
Correct the forming dimension if there are any deviations
between the actual dimension and the specified dimension (see
"Setting the forming dimension" in Section 5).
Содержание ET4400
