Danfoss EM-PMI240, Руководство пользователя

Страница: 24 / 59

Transportation
Heavy equipment. Handle with care during transportation.
Electric machine is shipped in rst class condition. It has been inspected and packed correctly to
prevent damage from ordinary handling during shipment. During transportation, shocks, fails and
humidity should be avoided. Protect the cooling holes for transportation.
The weight of the electric machine can be found on the machine rating plate, and in the product
data sheet.
Receiving and unpacking
Do not touch the electric machine during the insulation resistance check. Discharge the electric machine afterwards.
Do not touch the electrical terminals when the rotor is rotated. The electrical terminals have dangerous voltage during
rotation. Contact Danfoss representative if the rotor can't be rotated.
Check upon arrival and unpacking
The electric machine and the package must be inspected immediately upon arrival. Make
sure that the rating plate data in the cover letter complies with the purchase order. Any
external damage (in shaft-ends, anges, electrical interfaces and paint) must be photographed
and reported immediately.
It is recommended to measure the insulation resistance of the machine upon arrival, or before
installing the electric machine. Refer to Chapter Insulation resistance test.
Lifting
Use correct, adequately dimensioned lifting devices and inspect them before lifting.
Do not lift from the shaft of the electric machine!
Do not apply any excess weight on the electric machine when lifting.
Use correct lifting slings. Use correct position and angle of lifting. Permissible range of lifting angles is from 0° to 30º.
EM-PMI240
5. Transportation and storage
| BC355256345493en-000103
©
Danfoss | Produced By: Danfoss Power Solutions | September 2020 | 23