Danfoss 45 K2 Series, Инструкции по ремонту

Страница: 11 / 40

2. Slide the cylinder block assembly (P010) out of the pump housing by pushing on the shaft. Push the
shaft only far enough so that the cylinder kit may be removed by hand. Keep track of the three small
hold-down pins (K046) located inside the cylinder kit.
Once removed, set the cylinder kit in a protected area. Contamination or scratches may lead to poor
performance or pump failure.
P109041
Input shaft and swashplate
1. Rotate the swashplate (B040) until level with pump housing.
2. Pull the shaft (J010) from the shaft seal and bearing kit.
3. Pull to remove the front tapered roller bearing (B050).
4. Carefully pry to remove the journal bearings (B030) and retaining pins (B071) from the pump housing.
Record the location and orientation of the journal bearings if they are to be reused. If necessary,
remove the front bearing cup (B060) from the pump housing.
Repair Instructions
Series 45 Frame K2 Axial Piston Pumps
Disassembly
© Danfoss | April 2017 AX00000305en-US0101 | 11