Danelec Business System
Danelec Marine S-VDR/VDR USER GUIDE
Confidential. Copyright Danelec Marine A/S
DBS11343-11
Page 20/44
6 Connecting a PC to the S-VDR/VDR
6.1 PC setup
The PC is used to extract data from the S-VDR / VDR. Before connecting the PC to the
S-VDR/VDR the network interface of the PC must be configured. The default IP address of the
S-VDR/VDR is 10.0.0.100, Subnet mask 255.255.255.0. To connect to the S-VDR/VDR, the PC
network adaptor must be set to an IP address in the same range.
The recommended IP address for the PC is, IP address: 10.0.0.10, Subnet mask 255.255.255.0.
Note:
If the IP address of the VDR has been changed to another value than the default, the PC network
adaptor must be configured accordingly.
Note:
The IP address of the computer may not be the same as the IP address of the S-VDR/VDR.
Follow these steps to configure the PC:
1. Open the network and sharing menu in the control panel
Click Start menu
→
Control Panel
2. In the control panel click on Network and Sharing center
3. In the Network and Sharing Center window click on Change adapter Settings
