d&b audiotechnik SL, Руководство пользователя

Страница: 34 / 47

Tension mode setup
Provided...
▪ The touring cart is loaded as described in and in position.
▪ The load beam has already been attached to the flying frame,
as described in the previous section
Þ
Chapter 4.1.1
"Attaching the Load beam to the Flying frame" on page 25 and
the hoists are connected.
▪ The safety chain has already been attached to the flying frame,
as described in
Þ
Chapter 4.1.2 "Secondary safety"
on page 27.
... proceed as follows:
1. Setting the splay angles
The Splay links have to be engaged manually cabinet by cabinet.
Proceed as follows:
1. On the cabinet, on which the splay is to be set, first release the
two Locking pins (pin [1] and [2]) on the cabinet below.
↳This will release the Splay link and the cabinet becomes
movable.
2. On the cabinet itself also release the two Locking pins (pin [1]
and
[2]) and fold out the Splay link of the upper cabinet.
3. Preset the splay angle (e.g 2°).
4. Insert the Splay link of the upper cabinet into the rigging
strand.
5. Slightly lift the back of the cabinet until the Splay link has
engaged and reinsert Locking pin [2] (Safety pin).
6. For the next two cabinets proceed in the same manner.
6 Tension mode setup
d&b XSL Rigging manual 1.1 en - preliminary - 34