KSLi arrays and assembly procedures
5. Rear link of the last SUB cabinet
The Rear link of the last cabinet can be kept in its park position.
6. Check the assembly
Before hoisting the array to its operating position, recheck the
actual status of the entire assembly according to the checklist given
Chapter 4 "Safety and system checks/Hoisting" on page 28.
7. Rig the cabling
Connect the cables and link cables according to the number of
amplifier channels and cabinets used.
▪ If the amplifiers are already wired and powered on, use their
System check functions or channel mute switches and a test
signal to check the correct operation and routing of all channels
and cabinets.
▪ Alternatively, check the wiring using the Array verification
function in R1.
3.4 Mixed array configuration
3.4.1 Limitations
NOTICE!
For a mixed setup, the Z5744 KSLi-SUB Mounting frame must
always be used as a suspension device while the Z5745 KSLi-SUB
Mounting adapter is required in addition.
The Z5745 KSLi-SUB Mounting adapter is designed to support a
total system weight of 600 kg (1322.8 lb) - SWL including all
rigging components.
Together with the Z5744 KSLi-SUB Mounting frame, this allows the
suspension of mixed array setups consisting of a maximum of 6 x
KSLi-TOP cabinets below 2 x KSLi-SUB cabinets.
3.4.2 Order of assembly
1. Suspend the KSLi-SUB Mounting frame
1. Suspend the Mounting frame according to your onsite
requirements.
2. Lift the frame to a suitable working height.
d&b KSLi Rigging manual 1.1 en
22
