d&b audiotechnik 5D, Руководство для стартапов

Страница: 16 / 24

Startup
5.2.2 Analog audio input/link connectors
IN (A1 - A4)
A 3-pin Euroblock connector (male) is provided for each analog
input to accept the supplied 3-pin Euroblock connector (female). To
feed (link) the input signal on to the next device in the signal chain,
the connector can also be used as a cable tap.
Technical specifications
INPUT A1 - A4 3-pin Euroblock male
Pin assignment ( ) GND, neg., pos.
Input impedance 15 kΩ, electronically balanced
CMRR @ 100 Hz/1 kHz / 10 kHz > 54/> 54/> 50 dB
Maximum input level (balanced/unbalanced) +18/+12 dBu
Input level @ 0 dBFS +27.3 dBu
5.2.3 ETH1/ETH2 - Dante
ETH1/ETH2
LED indicators
The two LED indicators of the respective connector socket in use
indicates the following states:
Green
Illuminates permanently when the device is connected
to an active network and flashes as long as a data
stream is transmitted.
Yellow
Is off when the speed is 100 Mbits and illuminates
permanently when the speed is 1 Gbits.
A dual Ethernet port with a built-in 2-port Ethernet switch (1 Gbits/
100 Mbits - peer-to-peer) is provided, enabling standard remote
control via the d&b Remote network (OCA/AES70 and SNMP IP
address:Auto (DHCP+LL) or Manual) as well as digital audio
networking on either of the connector sockets.
It allows either daisy-chain or star-wiring topology. How ever, star-
wiring topology is strongly recommended.
The device will subscribe to the network with two MAC addresses
and will also (if DHCP is present in the network) get two IP
addresses: 1x µC and 1x Dante-Chipset.
Dante
The device is Dante enabled and accepts four Dante RX channels -
Primary only.
The chipset is configured using Dante Controller (IP mode and IP
address are not synchronized between µC and Dante).
A Dante "Clear config." will only be effective for Dante and does
not effect the device itself.
Technical specifications
Inputs 4 RX channels
Sampling 48 kHz/96 kHz
Synchronization Sample Rate Converter (SRC)
Latency
≥
1 ms.
Network Primary, 2 RX flows (Unicast or Multicast)
d&b 5D Start-up manual 1.1 en - preliminary - 16