重心位置展示
5
Control Directions Tests
09
Set and Adjust
设置和调试
常规飞行(Normal Flying) 3D飞行 部分飞机支持(3D Flying only support some models)
副翼 Aileron ±（15°-30°） ±40° 或者更大(or larger)
平尾 Elevator ±15° ±40° 或者更大(or larger)
垂尾 Rudder ±15° ±40° 或者更大(or larger)
常用襟翼 Flap （起飞 take-off）15°-20° （降落 Landing）20°-40°
部分特殊机型会有V型尾翼，襟翼，前缘机翼或舵面很小等，可以以常规飞行的角度作为参考，在您不确认且没有有经验人员指导
的情况下，我们建议您先以小角度试飞以确认您的设置是否正确。
Some special models will have V-tails, flaps, leading edge wings, etc., which can be used as a reference for conventional
flight angles. If you do not confirm and there is no experienced person to guide you, we recommend that you first test
at a small angle to confirm that your settings are correct.
Elevator
Aileron
15°-30°
15°
15°
15°
15°
15°-30°
通常情况下，舵面角度的设置如下：
Usually, the control throws set as below:
≈90mm
Display the C.G
Elev
at
or
升降舵
方向舵
副翼
Ailer
on
Rud
der
遥控器动作
飞机反应
升降杆下拉
Direction rod to the left
升降杆上推
Direction rod to the right
Steering rod to the left
Steering rod to the right
Lifting rod up
Lifting rod down
转向杆向右
转向杆向左
方向杆向右
方向杆向左
地面控制方向测试
升降舵
副翼
Rudder
方向舵
训练飞行模式参考上图设置，运动3D飞行模式请参考3D飞行。在3D飞行时可使用混控把副翼和襟翼联合起来。
≈90mm
注意：设置重心时，可用电池配重，调整电池位置以达到合
适的重心。然后用魔术胶带把电池固定在仓身内。
Note:When you adjust CG, you can use battery as
balance weight, adjust battery positon to find the
suitable CG, then fasten the battery on the cabin with
magic tape.
About the training flying mode, please refer to above picture's setting;
For sport 3D flying mode, please refer to 3D flying.Use mixed control to connect aileron and flap in 3D flying.
