1 Chrome Rail (for attachment to Worktop)
4 Self-Tapping Screws (to attach chrome rail)
1 CO2 Cylinder Support Stand
1 CO2 Cylinder (empty)
1 CO2 Regulator (high/low pressure gauges)
1 CO2 Air Line Hose (red)
2 CO2 Air Line Hose Connectors (black)
1 Beer Keg Coupler
1 Beer Tower Unit (complete with faucet, hose and wing nut)
1 Rubber Washer (to be installed inside wing nut)
1 Beer Tower (Quick Connect) Bayonet Attachment (beer tower installation)
4 Machine Screws (to attach bayonet to beer tower)
1 Gasket (beer tower base)
1 Pull Handle (beer tower faucet)
1 Beer Keg Stand (required for 30 liter keg installations only)
1 Protective Plate (refrigerator cabinet floor)
2 Cantilever Wire Shelves (conversion to all refrigerator application)
1 Chill 'n Tap Exterior Cabinet Plug (located on worktop)
1 CO2 Air Line Hose Plug (located exterior rear cabinet)
1 Plastic Drip Tray (2 piece)
CHILL'N TAP ACCESSORIES (included with this unit)
4
"WARNING"
CO2 CAN BE DANGEROUS
WARNING
: CO2 Cylinders when charged contain high-pressure compressed gas which can be
hazardous if not handled properly. Read and understand the following procedures for C02 cylinders
before installation.
1. Always connect CO2 gas cylinder to a regulator. Failure to do so could result in an explosion
with possible death or injury when the cylinder valve is opened.
2. Never connect C02 gas cylinder directly to beer keg.
3. Always secure C02 gas cylinder in an "upright" position.
4. Always keep CO2 gas cylinder away from heat.
5. Never drop or throw CO2 gas cylinder.
6. Always check the D.O.T. (Department of Transport) test date located on the neck of the cylinder
before installation. If over five (5) years, do not use, return the gas cylinder to gas supplier.
7. Never connect a product container unless there are two (2) safety mechanism's in the pressure
system;
(a) One at or on the CO2 regulator. (the regulator supplied with this unit is inclusive of such a
safety mechanism)
(b) One at or on the product container coupler or in the pressure gas line. (the keg coupler
supplied with this unit is inclusive of such a safety mechanism)
8. Always ventilate area after any leakage of CO2.
If it becomes difficult to breathe and/or your head starts to ache, abnormal concentrations of
carbon dioxide (CO2) may be present in the area. CLOSE THE MAIN VALVE ON THE CO2 CYLINDER,
VENTILATE AND LEAVE THE ROOM IMMEDIATELY.
CO2 gas cylinders should be stored in the coolest part of the establishment (preferably) at 70ºF (21ºC)
and must always be securely fastened in an "upright" position.