Appendix G – Regulatory Information 05/2008
Danaher
Motion
128
S200-VTS Product Manual
APPENDIX G – REGULATORY INFORMATION
G.1 Conformance
Requirements
The equipment described herein has been developed, produced, tested and documented in
accordance with the corresponding standards. During use conforming with requirements, the
equipment is not dangerous for people or equipment. Use conforming with requirements means
that the safety recommendations and warnings detailed in this manual are complied with and
that the applicable regulations for safety (machine directives, etc.) and noise suppression (EMC
Directives) are observed while operating the drive. At the end of its lifetime, dispose of or
recycle the drive according to the regulations applicable at that time.
G.2 CE
Approval
The CE initials confirm that the S200 drives satisfy all requirements of CE Directives. However,
the equipment is not ready to operate without additional installations (cable, motor, etc.). Thus,
all necessary tests and measurements had to be made on a typical installation. The test
installation with all peripheral devices, as well as the test results and measurements are
recorded in detail in documentation that is available from the manufacturer on request.
G.2
CE EMC Compliance
NOTE
If the connection method on your machine is different from the ones pictured in
this manual, or in the event of use of components other than those specified,
adherence to CE interference limit values cannot be guaranteed.
The machine builder should incorporate good EMC installation and wiring
practices in the machine design. Some machine designs require more EMC
consideration than others. For example, a multi-axis machine generates more
noise than a single-axis machine. Therefore, multi-axis machines may require
additional noise reduction techniques, such as a metal enclosure or clamping of
cables shields to an RF ground.