Dalsa X64 Xcelera-HS PX8, Руководство пользователя

Страница: 45 / 91

X64 Xcelera-HS PX8 User's Manual X64 Xcelera-HS PX8 Reference
•
43
When using the shaft encoder signals, the user can choose to connect to the opto-coupled inputs or
the RS-422/TTL inputs (which support a higher maximum pulse frequency). The imaging
application chooses which shaft encoder input to use via a board parameter (described following
the table below).
The following table describes the line trigger source types supported by the X64 Xcelera-HS PX8.
Refer to the Sapera Acquisition Parameters Reference Manual (OC-SAPM-APR00) for descriptions of
the Sapera parameters.
CORACQ_PRM_EXT_LINE_TRIGGER_SOURCE
The following table defines the trigger input source parameter values specific to the Xcelera-HS
PX8.
PRM Value Active Shaft Encoder Input
0 Default
1 Use phase A
2 Use phase B
3 Use phase A & B
4 From Board Sync
5 Phase A & B,
shaft encoder after pulse drop/multiply output to Board Sync
6 Phase A & B,
camera line trigger output to Board Sync
7 Phase A & B,
camera line trigger output to Board Sync only while grabbing
Table 7: Line Trigger Source
CORACQ_PRM_EXT_LINE_TRIGGER_SOURCE full description relative to trigger type
and X64 Xcelera-HS PX8 configuration used:
PRM Value X64 Xcelera-HS PX8
configuration & camera
input used
Input used as:
External Line Trigger
Input used as:
External Shaft Encoder
if
CORACQ_PRM_EXT_LINE_
TRIGGER_ENABLE = true
if
CORACQ_PRM_SHAFT_
ENCODER_ENABLE =true
0 Camera #1 Shaft Encoder Phase A Shaft Encoder Phase A & B
1 Camera #1 Shaft Encoder Phase A Shaft Encoder Phase A
2 Camera #1 Shaft Encoder Phase B Shaft Encoder Phase B
3, 5, 6, 7 Camera #1 n/a Shaft Encoder Phase A & B
4 Camera #1 From Board Sync From Board Sync
Table 8: CORACQ_PRM_EXT_LINE_TRIGGER_SOURCE – Parameter Values