Rad-icon 1520 GigE User Manual
19
Teledyne DALSA
Connecting
1.
After the install is complete, plug in the detectors communication cable.
2.
Power up the detector.
3.
After powering up the detector, the application automatically detects the detector.
This may take 30 to 60 seconds. Wait until the detector connected indicator in the task
bar (shown below) has confirmed that a connection has been established (the red cross
over the camera icon disappears).
Checking detector status and information in Gigabit Ethernet
After the detector connection has been established, the status of the connection can be
displayed by right clicking on the camera icon in the task bar and selecting “SHOW
Status Dialog Box.”
When you add or remove a detector from the network, it is automatically detected by the
GigE server. A manual network scan can also be launched from this menu by selecting
“Scan Network.” This action will refresh the information of the device connected to the
network. The “About Sapera GigE Server” option will display the version of the installed
GigE driver.
Selecting the “SHOW Status Dialog Box” will open the device status window, which
displays the basic information of the detector
-
Serial Number
-
Model Name
-
MAC Address
-
Packet size, which should be 9000
-
Firmware version (build number)
-
IP addresses of
o
Detector
o
Network Interface Card on host system to which the detector is
connected
The default assigned detector IP address can be modified using the Teledyne DALSA
Network Configuration Tool, which is part of the installation package.
