dallmeier DLS 24 S1, Руководство по установке и настройке

Страница: 205 / 215

205 Dallmeier electronic GmbH & Co.KG
The video input C1 is to be
seen as a reference input
for the system. A video
signal must always be
active at this input.
The fault message usually
just appears when
processing the display
sequence in "Auto" mode.
Without proper termination
of the monitor output, the
level of the output signal is
not normal.
The output signal on M2 is
diverted to this card when
MCD-25 is used.
Even though all of the
software settings are correct,
contact control via the
Contact IN is not possible.
Time is not shown on
monitor 2.
Malfunction, incorrect data
transfer or functional
limitation.
When the recorder is
started, the monitor flickers
and then stays dark.
A camera was removed from
the "Cameras" dialog.
The system signals a fault
(whistle), however.
MCD-25 in conjunction with
a VGA monitor: The split, in
which the menu is also
displayed, appears much too
bright.
Connections to contact IN
not occupied correctly.
Check whether the
connections to contact IN
are correct.
"Monitor 2 as Monitor 1"
must be activated in the
"Sequencer" menu.
The connection panel is
soiled. Remove, clean and
replace connection panel.
Check whether a video
signal is active at input C1;
connect a video signal if
necessary.
The camera is still entered in
the display sequence of the
sequencer.
Remove the respective
camera from the display
sequence of the sequencer.
Monitor output 2 on the
recorder must be terminated
with 75 Ohms.
This termination could be via
a monitor or a terminating
resistor.
24 Troubleshooting
Additional sources of faults and information on the cause and
remedy are found in the operating instructions.
Fault
Possible cause and
remedy
Additional information