DIS-2/M StreamerPro HDD Large UTP
44
Dallmeier electronic
10.3
Recording
NOTE
The record mode is set on a track basis.
¾
Click on Recording.
¾
To configure the settings for a track, click on the relevant track in the selection list.
The Recording settings dialog box will open.
¾
Set the recording mode in the Mode field.
¾
Select the corresponding tab.
¾
Make the necessary settings.
10.3.1
Permanent
The system will record without interruptions if it is set to Permanent recording mode. No
other settings are required for this recording mode.
¾
Confirm with OK.
10.3.2
Contact
If you have selected Contact mode, the system will only record if an appropriate contact is
closed. Recording will then stop again when the contact is opened. The contact you wish to
use here can be set in the Contact tab.
¾
In the Rec. contact (A) box, select the desired
contact on Contact IN.
¾
If the contact used is an “opener“ (default
condition = contact closed), check the invert
signal checkbox (B).
¾
Confirm with OK.
Fig. 10-8
Fig. 10-9: Contact tab in the Recording settings
dialog
A
B