DIS-2/M StreamerPro HDD Large UTP
39
Dallmeier electronic
10 Recording settings
If the module is fitted with hard disk drives, in addition to streaming it can also be configured
for local recording.
For this purpose the encoder which is relevant for recording and streaming must be
configured first of all. Tracks are then defined for recordings by assigning them to the hard
disk drives. Finally the recording mode can be defined for each track.
10.1
Encoders
Depending on the version, the devices in the DIS-2 series have one or two encoders. These
may be configured separately if necessary. Encoder 1 is always used for local recording in
all tracks. Like Encoder 2, it can also be used for streaming.
¾
Open the Encoder settings dialog via Tracks … > Encoder settings.
¾
Select the relevant encoder as
Input.
¾
Please note the explanations
below.
¾
Make the necessary settings.
¾
Finally confirm with OK.
Encoder-Mode
In Encoder-Mode you can select the standard using which the audio and video data are to
be compressed. MPEG2, MPEG4 and MJPEG are available for the DIS-2/M StreamerPro
HDD Large UTP.
Frames/Second
The frame rate in frames per second (fps) is used to define the number of saved individual
frames per second. The higher the frame rate, the more fluid the playback.
NOTE
Please note that an audio recording is only possible at a video
rate of 25 images per second (or 30 per seconds for NTSC).
Audiobitrate
The audio bit rate setting allows you not only to control the audio quality, but also the
amount of required hard disk space to a certain extent. The higher the audio bit rate, the
better the audio quality. A higher bit rate, however, requires more hard disk space than a
lower bit rate.
Fig. 10-1