DIS-2/M StreamerPro HDD Large UTP
36
Dallmeier electronic
9.3
Video streaming
The module for sending audio and video data can be configured using an IP-based network
in the Video Streaming dialog.
¾
Open the Video streaming dialog via Common settings > Video streaming ....
¾
Before configuration please note the
explanations below.
¾
Set the relevant Encoder if necessary.
¾
Set the Mode.
¾
Enter the IP adress or Multicast IP
adress.
¾
Enter the Port.
¾
Enter the range restriction for data
packets as TTL.
¾
Set the Packet size for the data packets.
¾
Finally confirm with OK.
9.3.1
Mode
The transfer protocol and encoding of the audio and video data are defined in Mode. A
distinction is made between unicast and multicast for this purpose (see below).
MPEG
The audio and video data are encoded using the MPEG-2 program stream.
The encoder set as the Input must work in encoder mode MPEG-2 (Tracks ... > Encoder
settings).
The transfer is made in the form of a pure stream (without protocol).
RTP/MPV
The video data are encoded using the MPEG-2 standard (MPEG Video). The audio data
are not taken into consideration, even if the module records with audio locally.
The encoder set as the Input must work in encoder mode MPEG-2 (Tracks ... > Encoder
settings).
The data will be sent using the RTP protocol, which optimizes the synchronization of the
data packets at the receiver. The protocol implementation is based on the following standards:
RFC3550
RTP Transport Protocol for Real-Time Applications
RFC3551
RTP Profile for Audio and Video Conferences with Minimal Control
RFC2250
TP Payload Format for MPEG-1/MPEG-2 Video
Fig. 9-23