22
Dallmeier electronic
DDF3000AV4-DN / DDF3000AV4-D
7 Preparing to configure
The camera is supplied with factory settings which enable it to be used for most scenarios
without further configuration. However, if required, the camera settings can be configured in
the OSD (On Screen Display) camera menu, either directly at the camera with the selector
(
B
) or via the UTC (Up The Coax) PicoRemote Box, a DMS / DLS recorder or PView.
NOTE
If using UTP video output, the camera configuration is only
possible with a passive UTP transceiver (e. g. Dallmeier DIS-
2/M UTP) or via UTP (RJ-45) / BNC video balun (impedance
converter).
NOTE
There must be no video distributor or signal amplifier between
the camera and the PicoRemote Box, the recorder or PView.
NOTE
Refer to the separate documentations of the devices or soft-
ware used.
7�1
PicoRemote Box
Direct
Camera
PicoRemote Box
CVBS monitor
Fig. 7-1
