DGM02
Device Manual
Made in Italy
DALCNET S.r.l.
36077 Altavilla Vicentina (VI)
–
Italy
Via Lago di Garda, 22
Tel. +39 0444 1836680
–
Rev.
06/12/2022 -
Pag.
13/32
SECTION: DALI GLOBAL SETTINGS
–
BUS 3
Only in Dali config mode it is possible to send and modify the commands of the DALI global settings pop-up menu which are:
“
TRANSMIT AS”:
o
“Address”:
send address commands
o
“Group”:
send group commands
o
“Broadcast”:
send broadcast commands
“SEND COMMAND OFF INSTEAD OF DAPC0“:
sends the DALI OFF command instead of the DAPC command to 0;
“SYSTEM FAILURE LEVEL “:
send the System Failure Level command in broadcast;
“POWER ON LEVEL “:
sends the Power On Level command in broadcast;
“FADE TIME “:
sends the Set Fade Time command in broadcast;
“DT8 MANAGEMENT “:
enables the management of DT8s;
“SYSTEM
FAILURE
COLOR “:
sends the System Failure Colour command for RGBW components;
“POWER
ON
COLOR “:
sends the Power On Colour command for RGBW components;
NOTE:
Only by pressing “APPLY” are the DALI commands sent.
To unlock the configuration of the other buses, put the DALI bus in DALI Controller mode.
