DALBO MAXIROLL 530, Руководство пользователя

Страница: 33 / 39

MAXIROLL
Side 33
Assembly
1 Assemble the new seals into the gland and the sleeve.
2 Lubricate the screw threads on the gland (pos. 3) and the cylinder casing (pos.
1) with oil.
3 Mount the gland (pos. 3) onto the piston rod.
4 Mount the sleeve (pos. 4) and the piston rod
with Loctite
. Make sure that the
screw threads are completely clean and free from oil or other impurities before
using Loctite.
Do not refill the oil for the first 12 hours after the application of
Loctite.
5 Lubricate the outermost seal of the sleeve that has contact with the cylinder
casing and the inside of the cylinder casing, then guide the piston rod into the
middle position of the casing.
6 Screw the gland onto the casing and tighten.
7 To mount the cylinder, see ”Changing Crackerboard depth adjustment cylinder”.
Dismounting/mounting of wheels
To dismount the wheels, lower the MAXIROLL until the discs are resting on the
ground and the wheels are clear off the ground.
Remove the lug nuts. The wheel can then be removed. After mounting a new wheel,
screw on the lug nuts and tighten with a “hard hand”. Next, lower the wheels until
they are touching the ground and tighten the nuts to a torque of 300 Nm.
It is important that the wheel lug nuts and the mounting surface of the rim are clean;
otherwise the nuts will become loose.
Changing wheel bearings
Fig. 30
1. Remove the hubcap (pos. 21).
2. Take out the split cotter pin (pos.
20).
3. Unscrew the castle nut (pos. 19).
4. Knock the hub off the axle (pos. 2).
5. Remove the bearings (pos. 17+18).
6. Remove the seal (pos. 19).