DALBO MAXICUT 920, Руководство пользователя, Страница: 28 / 49

MAXICUT
Page 28
It is possible to equip the machine with mole planks, which are mainly intended to even out
mole holes and other uneven grass areas. The mole plank is therefore mainly intended to be
used in combination with the grass drums.
Fig. 14
Power
The power requirement for driving with mole planks depends a lot upon the soil type, the for-
ward speed as well as the unevenness of the grass areas.
Power requirements in [HP] mole planks
Model 920
Mole planks power requirements [ HP min. ] 20 – 40
Driving and operating
The mole planks can be adjusted in terms of how hard they are pushed into the ground via
hydraulics (Hydraulic hose marked with: Green).
Installation/Retrofitting
If no plates are installed on the machine, follow-up installation guidelines will accompany the mole
planks or be changed in the following way.
Fig. 15
1. The machine must be folded out, lowered
to the ground and the tractor stopped.
2. If plates are installed, remove these first.
This is done by supporting the plate
frames and then removing the nails A
and B.
3. The mole plank is installed in the same
way.
Saw equipment
It is possible to equip the machine with saw equipment as an option.
The saw equipment can be used for subsequent crops or care of grass areas.
A
B