DALBO MAXICUT 920, Руководство пользователя, Страница: 24 / 49

MAXICUT
Page 24
Power
The power requirement for driving with wave plates depends a lot upon the soil type, the
working depth and the forward speed.
Power requirements in [HP] wave plates
Model 920
Wave plates power requirements [ HP min. ]
50 – 100
Hose markings
Hose markings
Cylinder name Colour Outlet Function
Extra equipment Green Double-acting
For lifting and adjusting the extra
equipment
Driving and operating
It is important that you have lowered all 3 plate sections completely before folding the ma-
chine as these will otherwise go against each other and the main frame underneath and un-
fold.
The wave plates are spring-installed and therefore flexible if they encounter resistance in the
ground.
The maximum pressure that can be over the wave plates is factory pre-set. That means that
even if one sets full pressure from the tractor, it will be regulated such that only the pre-set
pressure is put on the wave plates.
The sections are fitted with hydraulic weight distribution so that the pressure is evenly dis-
tributed between the 3 sections. This causes the system to be set to float position after the
system has been pressurised to activate the hydraulic wall distribution.
The system also allows the individual section to go further if, for example, one should encoun-
ter an obstacle.

It is strongly recommended to have the plate sections' hydraulic lever in float po-
sition during work in the field. For optimal work in the field and so as not to dam-
age the hydraulic system (Hose marked with: Green).
When turning in the field or for sharp turns, all the plate sections must be lifted off the ground
so as not to damage the plates.
This causes a workflow as follows (only for extra equipment)