Daktronics ColorSmart BB-3101, Руководство пользователя, Страница: 20 / 122

14 Electrical Installation
4.5 Statistics Display Signal Connection
Figure 11 shows the connections required between a wired scoreboard and two statistics
displays. Refer to Figure 7 for more information about connecting the signal wiring that runs
from the scoreboard to the controller. See also Drawing A-124688 in Appendix E .
1. At a minimum, use a paired, 22 AWG shielded cable (Daktronics part # W-1077) and
connect the cable to a dual
1
/
4
" J-box at the control console end.
2. Route the cable from the J- box on the control console end to a J-box near the display.
3. Install the
1
/
4
" phone plug (Daktronics part # 0L-40683) to the display end of the
cable. Be sure to connect the cable shielding only in the J-box on this end.
Note: DO NOT connect cable shielding at the J-box near the control console.
4. Route the
1
/
4
" phone plug from the J-box near the display to the scoreboard.
5. Insert the plug into the Signal In (J31) jack located on the top of the scoreboard.
6. Connect a
1
/
4
" phone plug between the Signal Out (J32) jack on top of the scoreboard
to the Signal In (J31) jack on top of the right (GUEST) stat panel.
7. Connect another ¼" phone plug between the Signal Out (J32) jack on top of the right
(GUEST) stat panel to the Signal In (J31) jack on top of the left (HOME) stat panel.
Figure 11: Statistic Display Installation