Daktronics BA-515, Руководство пользователя, Страница: 44 / 208

Mechanical Installation
40
2.
Using the mounting channel as a template, drill
9
/
16
" holes in the upper and lower
rear flange of the ad panel where the C-channel supports will be placed.
3.
Position the C-channel inside the ad panel cabinet along the upper and lower back
flanges.
4.
Place square nuts inside the channel and thread the long rods through both the C-
channel and the flange.
5.
Lift the ad panel into position with the rods still in place.
6.
With the threaded rod straddling the beams, place mounting angles over each pair of
bolts and secure with
1
/
2
" lockwashers and hex nuts.
7.
When the panel is adjusted to the final desired position, tighten hex nuts firmly.
Some ad panels have back sheets that must be removed before the display can be installed.
After marking and drilling holes in the upper and lower rear flanges of the ad panel, remove
the back sheets above and below the hole locations. Position the C-channel inside the cabinet
and attach the square nuts to the threaded rods as described above. Be sure to replace the
back sheets after placing the square nuts inside the channel and threading the rods through
the holes in the upper and lower flanges.
Models BA-515-11 and BA-518-11
With Models BA-515-11 and BA-518-11, ad panels can be mounted directly to the end of the
scoreboard. Refer to
Drawings A-52585 and A-52811 for mounting details.