Daktronics BA-1518-11, Инструкция по установке, эксплуатации и техническим характеристикам

Страница: 6 / 158

All references to drawing numbers, appendices, figures, or other manuals are presented in bold
typeface, as in this example: “Refer to Drawing A-114667 for the location of the driver
enclosure.” Additionally, any drawings referenced within a particular subsection are listed at the
beginning of that subsection in the following manner:
Reference Drawing:
Shop Drawing; 16 High 2 ½" Small Matrix ................................... Drawing A-114667
Daktronics identifies each manual by assigning an engineering document, or ED, number, which is
located on the cover page. This manual, for example, would be referred to as
ED13313 .
The serial and model numbers of a Daktronics scoreboard can be found on the ID label on the display.
The label will be similar to
the one shown in
Figure 2 .
When calling Daktronics
Customer Service, please
have this information
available to ensure that
1-2 Introduction
your request is serviced
as quickly as possible. For
future reference, note your scoreboard model number, serial number, and installation date on the front
page of this manual.
Figure 2: Scoreboard Label
Daktronics displays are built for long life and require little maintenance. However, from time to time,
certain display components will have to be replaced. The Replacement Parts List in
Section 4
provides names and part numbers of components that may require replacement during the life of this
display.
Following the Replacement Parts List is an explanation of Daktronics exchange and replacement
programs. Refer to these instructions if you must replace or repair any display component.
1.2 Daktronics Nomenclature
To fully understand some Daktronics drawings, such as schematics, it is necessary to know how
various components are labeled in those drawings. You will find this information useful when trying
to communicate maintenance or troubleshooting efforts.
The label "A" on a drawing item typically denotes an assembly. An assembly can be a single circuit
board or a collection of components that function together, usually mounted on a single plate or in a
single enclosure.
In addition, the following labeling formats might be found on various Daktronics drawings:
+ "TB_ _" denotes a termination block for power or signal cable.
+ "F_ _" denotes a fuse.
+ "E_ _" denotes a grounding point.
+
"J_ _" denotes a power or signal jack.
+
"P_ _" denotes a power or signal plug for the opposite jack.