page
1
MAN#650255A
AI-291/AI-292
MLX-9000 Series Installation Kit for
American Iron Horse V-bar mount
Gauge installation:
1.
Remove the two screws from the bottom of the original gauge that hold it to the bars and remove the gauge.
2.
Disconnect the original gauge harness from the bike at the two connectors located close to the frame under
the front side of the tank.
3.
Remove the stock harness from the bike noting where the harness is routed.
4.
Route the wiring harness from this kit back into the routing location of the original harness.
5.
Remove the back plate from the MLX-9000 Series gauge.
6.
Work the grommet from the wiring harness into the slot on the back cover.
7.
Connect the harness from this kit to the MLX-9000 Series gauge.
8.
Put back cover back onto MLX-9000 Series gauge so that the gauge will face up when mounted.
9.
Mount the gauge as shown below for your mounting position.
Below Bar Mount
Above Bar Mount
1.
Locate all mounting hardware
1. Locate all mounting hardware
Kit includes:
(1) Wiring harness
(1) Mount bracket
(1) Mount cap
(2) 10-
32 X 3/8” socket head screws
(2) 1/4-20 X 3/4" socket head screws
(6) Cable ties
(1) Installation kit instruction manual