MAN# 650061
ION-05 VOLTAGE GAUGE
Wiring:
PWR
-
connect to fused switched 12 volt power. (An accessory terminal will work for this.)
DIM
-
Night Dimming: connect to the head light switch.
SND
-
voltage measuring point, usually jumper over to the PWR terminal.
Gauge case
-
connect to a main ground location
Mounting:
The gauge requires an oval hole 1-7
/16” high x 3-1/16” wide. It should be inserted into the opening from the
front and the 2 L-clamps will be installed from the back. Tighten a nut on each of the L-clamps so that the gauge is
secure. Gauge depth to the back of the case is 1”. Gauge depth including the mounting studs is 1-7/8”.
Factory settings:
Lo warning point:
11.1 V
Hi warning point:
15.4 V
The voltage gauge will operate in the voltage range of 8.0
– 17.0 and read correct between the voltage range of
1.0 - 18.0 volts.
It has a user adjustable lower and upper warning level. This can be set to indicate low voltage and overcharging
conditions.
The SND terminal is the voltage sensing input. To read the vehicle system voltage, connect this to the PWR
terminal. To read the voltage at a second battery or other remote location, connect a wire from the SND terminal to
the voltage to be monitored.
