MAN #650589A
BIM-01-2-MSD
Bus Interface Module for MSD EFI
setup/status switch
BIM-01-2-MSD
Bridge Module for MSD EFI Systems
www.dakotadigital.com
605-332-6513
INPUT
BIM-xx-2 power & data connectors.
Either one can be used.
BIM-xx-2 18 inch power/data harness
Connect directly to
another BIM-xx-2
Connect to the BIM-01-2
if you need to connect to a
BIM-xx-2
Connect to the BIM-01-2
MSD EFI-Y-adapter harness
Connect in-line MSD EFI
This Bus Interface Module is designed to read engine information from MSD Atomic EFI TBI kits. Atomic EFI LS is not
compatible. This module is connected to the MSD EFI through the included Y-adapter harness. This can be plugged in
line with the Atomic handheld display or the throttle body.
There are two interface (I/O) ports on the module. Either one can be connected to the gauge system or to another
module, allowing several units to be daisy chained together. Do not connect the I/O port to anything other than a Dakota
Digital gauge or BIM. Do not mount the module in the engine compartment; it should be mounted in interior of the vehicle.
The engine and transmission information that is available from the unit depends on the EFI module programming and
add-ons. The possible values are: engine RPM, engine coolant temperature, intake/manifold air temperature, oil pressure,
fuel pressure, average A/F ratio.
Data that should always be available: RPM, engine temp, intake/manifold temp, fuel pressure, A/F ratio
Data that is add-on dependent: oil pressure
