Daken 84201, Инструкция по монтажу, Страница: 7 / 21

12 13
ENG ENG
MOUNTING HOW IT WORKS
MAINTENANCE
ADVICES
STEP 4: SHELL MOUNTING
If necessary, use the plastic shims to align the half-flanges.
CAUTION Do not remove the Warranty Seal behind the shell.
If removed, the product is not under guarantee anymore.
Using the oval holes, calibrate the chamfered half-flange.
Complete mounting with short or long M4 screws, according to the chosen
mounting.
Cut the exceeding part of the screws to avoid damaging the seal of the van.
Check that the device works properly.
OPENING
CLOSING
Insert the key and turn it 180° clockwise; turn the shell in the opposite direction.
Turn the key 180° anticlockwise and extract it. The device is NOT secured.
Securing is at complete discretion of the user.
Make sure mounting is performed by technicians.
Lubricate the cylinder with a specific product every 2500 cycles and at least
every six months. A silicone lubricant is recommended.
When washing the vehicle, avoid pointing the water jet directly on the device.
Periodically check that both the product and the lever work properly.
Do not pry open the device by forcing the key.
Use only the key included in the kit to open/close the device.
Use only the original components included in the kit.
It is recommended to secure both the van lock and the central locking of the
vehicle.
Insert the key and turn it 180° clockwise; turn the shell in the same direction
up to the lock symbols are on vertical axis. Turn the key 180° anticlockwise and
extract it. The device is secured.
Open the movable door and place the external shell on the half-flange,
turn the shell 180° . F
From the inside of the movable door, fix the shell with the stop screw M3.5x14 .
G
STEP 3: HALF-FLANGES MOUNTING
Place the 2 rubber protections and the two half flanges in correspondence
with the holes, as follows :
• Straight half-flange: on the movable door
• Chamfered half-flange: on the fixed door or van body
E