Installing the DoorPhone
96
Required equipment
• Drill and 6mm dia. Bit
• If the cable goes through the pillar, drill and 8mm dia. bit minimum.
• Philips or pozidrive no2 type screwdriver for mounting screws
• 3.5mm dia. flat screwdriver for terminal block screws
• All mounting screws and plugs are supplied.
➢
Installing the external caller unit
1
For ease of use,
we recommend you
install the external caller
unit approximately 1.20m
from the ground.
2
Use the drilling template
(provided at the end of
this manual), mark
and pierce with a 6mm
dia. drill.
A -
If the cable passes
through the pillar, use the
drilling template to mark
the cable hole (8mm dia.
drill bit recommended)
B -
If the cable goes
around the pillar, pierce
one of the openings located
on the sides of the caller
unit using a rat-tail file
or a cutter for cable entry.
4
Push out the 2 screw
covers using a flat
screwdriver at the back
of the external caller unit.
5
Run the cable (according
to step 3).
Fix the external caller
unit (screws and plugs
supplied). Re-fit the screw
covers.
6
Write the users name with
a permanent marker on
one of the labels. Stick one
of the transparent
protective labels over it.
To preserve water tightness, never attempt
to open the external caller unit!
1,20 m
A
B
3
!
For the installation
of armoured caller
units, see the mounting instructions
provided with the armoured housing.
!
This step is not necessary
for armoured housing.
!
