7
|
Operation
Installer and user reference guide
27
RXYTQ
VRV IV+ heat pump for high ambient temperatures
4P561157-1B – 2021.11
7.3.5 To operate the system (WITH cool/heat changeover remote control switch)
Overview of the changeover remote control switch
a
b
a
FAN ONLY/AIR CONDITIONING SELECTOR
SWITCH
Set the switch to for fan only operation or to
for heating or cooling operation.
b
COOL/HEAT CHANGEOVER SWITCH
Set the switch to for cooling or to for
heating
Note:
In case a cool/heat changeover remote control switch is used, the position of
DIP switch 1 (DS1-1) on the main PCB needs to be switched to the ON position.
To start
1
Select operation mode with the cool/heat changeover switch as follows:
Cooling operation
Heating operation
Fan only operation
1
1
1
1
1
1
1
1
2
Press the ON/OFF button on the user interface.
Result:
The operation lamp lights up and the system starts operating.
To stop
3
Press the ON/OFF button on the user interface once again.
Result:
The operation lamp goes out and the system stops operating.
NOTICE
Do not turn off power immediately after the unit stops, but wait for at least 5
minutes.
To adjust
For programming temperature, fan speed and air flow direction refer to the
operation manual of the user interface.
7.4 Using the dry program
7.4.1 About the dry program
▪
The function of this program is to decrease the humidity in your room with
minimal temperature decrease (minimal room cooling).
