Daikin Home Controls EKRRVATR2BA, Руководство пользователя

Страница: 26 / 40

26
Replacing batteries Replacing batteries
8 Replacing batteries
If the symbol for empty batteries (
Prg
Of
fset
AUT
O
MANU
BOOST
Mo
Tu W
e
Th Fr Sa Su
0
6
12
18
24
) appears, replace the
used batteries by two new LR6/mignon/AA batteries. You
must observe the correct battery polarity.
To replace the batteries of the accessory, proceed as fol-
lows
1. Open the battery compartment (B) by pulling it
down
(see figure 3)
.
2. Remove the batteries.
3. Insert two new 1.5 V LR6/mignon/AA batteries.
Make sure that you insert them the right way round
(see figure 11)
.
4. Close the battery compartment.
5. Pay attention to the flashing signals of the LED
while inserting the batteries (see „9.3 Error codes
and flashing sequences“ on page 30).
» After inserting the batteries, the accessory will per-
form a self-test (approx. 2 seconds). Afterwards,
initialisation is carried out. The LED will light up
orange and green to indicate that initialisation is
complete.
Attention! There is a risk of explosion if the battery
is not replaced correctly. Replace only with the
same or equivalent type. Never recharge non-
rechargeable batteries. Do not throw the batteries
into a fire. Do not expose batteries to excessive
heat. Do not short-circuit batteries. Doing so will
present a risk of explosion.
Used batteries should not be disposed of with reg-
ular domestic waste! Instead, take them to your lo-
cal battery disposal point.