Daikin FTXM-V Series, Руководство по обслуживанию

Страница: 156 / 172

Field Settings SiUS042113E
152 Part 7 Trial Operation and Field Settings
4. Field Settings
4.1 Temperature Display Switch
Procedure

Press the upper side of Temp button and On button at the same time for 5 seconds to change
the unit of temperature display.
4.2 When 2 Units are Installed in 1 Room
Outline
When 2 indoor units are installed in 1 room, 1 of the 2 indoor units and the corresponding wireless
remote controller can be set for different address.
Procedure 1. Remove the battery cover of the remote controller, and cut the address jumper (J4).
2. Press the center of
Temp button and Mode button on the remote controller at the same time.
3. Select A (address setting) with Temp

or Temp

button, and press Mode button to enter the
address setting mode.
Then, the indoor unit operation lamp blinks for 1 minute.
4. Press the indoor unit ON/OFF switch while the operation lamp is blinking.
 If setting could not be carried out completely while the operation lamp was blinking, carry out
the setting process once again from the beginning.
 After setting, press Mode button on the remote controller for 5 seconds to return to the
normal mode.
(R22009)