Printed Circuit Board Connector Wiring Diagram
SiENBE12-713
52
Printed Circuit Board Connector Wiring Diagram
1.4
Floor Standing Type
Connectors
PCB(1) (Sensor PCB)
PCB(2) (Control PCB)
PCB(3) (Service PCB)
PCB(4) (Display PCB)
Note:
Other Designations
PCB(2) (Control PCB)
PCB(3) (Service PCB)
PCB(4) (Display PCB)
1) S49
Connector for control PCB
1) S1
Connector for fan motor
2) S21
Connector for centralized control
3) S26
Connector for service PCB
4) S41
Connector for lower air outlet motor
5) S42
Connector for swing motor
6) S46
Connector for display PCB
7) S48
Connector for sensor PCB
1) S27
Connector for control PCB
1) S47
Connector for control PCB
1) V1
Varistor
2) JA
Address setting jumper
JB
Fan speed setting when compressor is OFF on thermostat
JC
Power failure recovery function
∗
Refer to page 321 for detail.
3) FU1
Fuse (3.15A)
4) LED A
LED for service monitor (green)
1) SW2
Changing upward air flow limit switch
2) SW4
Discharge changeover switch
1) SW1 (S1W)
Forced operation ON/OFF switch
2) LED1
LED for operation (green)
3) LED2
LED for timer (yellow)
Содержание FTKS20D3VMW
