Daikin FTKM18PVMK, Руководство по обслуживанию

Страница: 109 / 119

SiMT041509E Field Settings
Trial Operation and Field Settings 94
3. Field Settings
3.1 When 2 Units are Installed in 1 Room
Outline When 2 indoor units are installed in 1 room, 1 of the 2 indoor units and the corresponding
wireless remote controller can be set for different addresses.
Both the indoor unit PCB and the wireless remote controller need alteration.
Indoor Unit PCB
„
Cut the address setting jumper JA on the control PCB.
Caution Replace the PCB if you accidentally cut a wrong jumper.
Jumpers are necessary for electronic circuit. Improper operation may occur if you cut any of
them.
Wireless Remote
Controller ARC466 series
„
Cut the address setting jumper.
Caution Replace the remote controller if you cut the jumper on the left side.
The heating operation will not be available when the jumper on the left side is cut.
3.2 Jumper Settings
Indoor Unit
For the location of the jumper, refer to page 9.
Caution Replace the PCB if you accidentally cut a wrong jumper.
Jumpers are necessary for electronic circuit. Improper operation may occur if you cut any of
them.
(R9665)
JA
ADDRESS
ADDRESS
JC
JA
JB
ADDRESS:JA EXIST
1
CUT
2
(R18416)
ADDRESS
EXIST 1
CUT 2
Jumper
∗
Do not cut the left jumper.
Function Jumper When connected
(factory setting)
When cut
Fan speed setting when
compressor stops for
thermostat OFF. (effective
only in cooling operation) JB Fan speed setting ;
Remote controller setting The fan stops.
Power failure recovery
function JC Auto-restart The unit does not resume
operation after recovering
from a power failure. Timer
settings are cleared.