Daikin FCAG35BVEB, Инструкция по установке и эксплуатации

Страница: 15 / 20

13 Maintenance and service
Installation and operation manual
15
FCAG35~140BVEB
Split system air conditioners
4P535626-1C – 2019.09
1 Go to the home screen.
Cool
Set to
28
°C
2 Press.
Return Setting
Main Menu 1/2
Circulation Airflow
Individual Air Direction
Energy Saving Options
Schedule
Maintenance Information
Configuration
3 Select Circulation airflow
Return Setting
Main Menu 1/2
Circulation Airflow
Individual Air Direction
Energy Saving Options
Schedule
Maintenance Information
Configuration
4 Choose enable and confirm.
Return Setting Return Setting
Circulation Airflow
Enable/Disable
Enable
5 Confirm setting.
Return Setting Return Setting
Circulation Airflow
Save the settings?
Yes No
6 Go to the home screen.
Cool
Set to
28
°C
7 Check if Air Volume/direction
is set to automatic. If not set
to automatic.
Return Setting Return Setting
Air Volume/direction
Air Volume Direction
Auto
Auto
2 Turn on the unit by the user interface.
13 Maintenance and service
13.1 Precautions for maintenance and
service
CAUTION
Do NOT insert fingers, rods or other objects into the air
inlet or outlet. When the fan is rotating at high speed, it will
cause injury.
NOTICE
Never inspect or service the unit by yourself. Ask a
qualified service person to perform this work. However, as
end user, you may clean the air filter, suction grille, air
outlet and outside panels.
WARNING
Never replace a fuse with a fuse of a wrong ampere ratings
or other wires when a fuse blows out. Use of wire or
copper wire may cause the unit to break down or cause a
fire.
CAUTION
After a long use, check the unit stand and fitting for
damage. If damaged, the unit may fall and result in injury.
NOTICE
Do NOT wipe the controller operation panel with benzine,
thinner, chemical dust cloth, etc. The panel may get
discoloured or the coating peeled off. If it is heavily dirty,
soak a cloth in water-diluted neutral detergent, squeeze it
well and wipe the panel clean. Wipe it with another dry
cloth.
CAUTION
Before accessing terminal devices, make sure to interrupt
all power supply.
NOTICE
When cleaning the heat exchanger, make sure to remove
the switch box, fan motor, drain pump and float switch.
Water or detergent might deteriorate the insulation of
electronic components and result in burnout of these
components.
13.2 Cleaning the air filter, suction
grille, air outlet and outside panels
CAUTION
Turn off the unit before cleaning the air filter, suction grille,
air outlet and outside panels.
13.2.1 To clean the air filter
When to clean the air filter :
▪ Rule of thumb: Clean every 6 months. If the air in the room is
extremely contaminated, increase the cleaning frequency.
▪ Depending on the settings, the user interface can display the
TIME TO CLEAN AIR FILTER notification. Clean the air filter
when the notification is displayed.
▪ If the dirt becomes impossible to clean, change the air filter
(= optional equipment).
How to clean the air filter :
NOTICE
Do NOT use water of 50°C or higher. Possible
consequence: Discoloration and deformation.
1 Open the suction grille.
Standard panel:
1
Design panel: