Daikin EWAD620-C17C-SS, Руководство по обслуживанию

Страница: 92 / 304

General Outline ESIE10-01
1–86 Part 1 – System Outline
3
11
4
5
In case of sudden stop of the unit, follow the instructions on the Control Panel Operating Manual which
is part of the on-board documentation delivered to the end user with this manual. It is recommended
to perform installation and maintenance with other people. In case of accidental injury or unease, it is
necessary to:
Q
Keep calm.
Q
Press the alarm button if present in the installation site.
Q
Move the injured person in a warm place far from the unit and in rest position.
Q
Contact immediately emergency rescue personnel of the building or if the Health Emergency
Service.
Q
Wait without leaving the injured person alone until the rescue operators come.
Q
Give all necessary information to the rescue operators.
Warning:
Q
Before carrying out any operation on the machine, please read this instruction and operating
manual carefully. Installation and maintenance must be carried out by qualified personnel familiar
with the provisions of law and local regulations, and who has been properly trained or has
experience with this type of equipment.
Q
Avoid installing the machine in a place that could be dangerous during maintenance operations,
such as (but not only) platforms without parapets or railings, or areas not complying with the
clearance requirements.
Moving and lifting The machine must be moved and lifted by using cables, spacing bars and scales of appropriate
dimensions to the machine weight. This is stated on its identification plate. The table of weights
included in the manual should be considered as indicative only. Installation of certain accessories can
increase machine weight. Always refer to the dimensional diagrams supplied for any technical
information.
Block machine sliding on lorries to prevent damage to the panels and base frame. Avoid bumping,
jolting and impacts during unloading and/or moving the machine. Do not push or pull the machine from
any part other than the base frame. These falls could cause serious damages for which the
manufacturer will not be held liable.
All units of the series are supplied with lifting points market in yellow. Only use these points to lift the
unit, as shown in the figure.
Use spacing bars to
prevent damage to the
condensation bank.
Position these above the
fan grills at a distance of
at least 2.5 metres.
Only use the designated lifting points marked on the unit.
Lifting the unit
L1
L2
L3
L4
N.B.:
The lifting method
specified below if valid for
all EWAD-C-models