Daikin ETSHB16P30EF, Руководство по установке для специалистов

Страница: 224 / 308

10 | Configuration
Installer reference guide
224
EPRA14~W1 + ETSH/X(B)16P30+50EF
Daikin Altherma 3 H HT ECH₂O
4P679467-1 – 2022.02
Power saving function
Power saving function
NOTICE
Power saving function. The power saving function is only applicable for V3 models. If
you want to use the power saving function, on the outdoor unit PCB make sure to
connect X804A to X806A. For more information, see
"In case of V3 models" [
4
108].
Defines whether the outdoor unit power supply can be interrupted (internally by
indoor unit control) during stand-still conditions (no space heating/cooling nor
domestic hot water demand). The final decision to allow power interruption of the
outdoor unit during standstill depends on the ambient temperature, compressor
conditions and minimum internal timers.
To enable the power saving function setting, [E‑08] needs to be enabled on the
user interface.
# Code Description
[9.F] [E‑08] Power saving function for outdoor unit:
▪ 0:
No
▪ 1: Yes
Disable protections
INFORMATION
Protective functions – "Installer-on-site mode" . The software is equipped with
protective functions, such as room antifrost. The unit automatically runs these
functions when necessary.
During installation or service this behaviour is undesired. Therefore, the protective
functions can be disabled:
▪
At first power-on: The protective functions are disabled by default. After 12
hours they will be automatically enabled.
▪
Afterwards: An installer can manually disable the protective functions by setting
[9.G]: Disable protections = Yes . After his work is done, he can enable the
protective functions by setting [9.G]:
Disable protections
=
No
.
# Code Description
[9.G] N/A Disable protections :
▪ 0: No
▪ 1: Yes
Forced defrost
Forced defrost
Manually start a defrost operation.
# Code Description
[9.H] N/A Do you want to start a defrost operation?
▪ Back
▪ OK