Daikin D-Series, Руководство по обслуживанию

Страница: 86 / 479

Si18-525B Printed Circuit Board Connector Wiring Diagram
Printed Circuit Board Connector Wiring Diagram 73
1.3.4 FTK 50-71 A
Connectors PCB(1) ( Control PCB )
PCB(2) ( Power Supply PCB )
PCB(3) ( Display PCB )
PCB(4) ( Signal Receiver PCB )
Note: Other designations
PCB(1) (Control PCB)
PCB(2) (Power Supply PCB)
PCB(3) (Display PCB)
PCB(4) (Signal Receiver PCB)
1) S6 Connector for swing motor (horizontal swing)
2) S8 Connector for swing motor (vertical swing)
3) S21 Connector for centralized control
4) S24 Connector for display PCB
5) S26 Connector for signal receiver PCB
6) S32 Connector for heat exchanger thermistor
7) S37 Connector for power supply PCB
1) S36 Connector for control PCB
2) S201 Connector for fan motor
1) S25 Connector for control PCB
1) S31 Connector for room temperature thermistor
2) S27 Connector for control PCB
1) JA Address setting jumper
JB Fan speed setting when compressor is OFF on thermostat.
JC Power failure recovery function.
∗
Refer to page 193 for detail.
2) LED A LED for service monitor (green)
1) V1 Varistor
2) FU1 Fuse (3.15A)
1) LED1 LED for operation (green)
2) LED2 LED for timer (yellow)
3) LED3 LED for HOME LEAVE operation (red)
1) SW1 (S1W) Operation switch