Daikin CTXA15A2V1BW, Руководство пользователя, Страница: 49 / 56

8 | Troubleshooting
User reference guide
49
FTXA25~50(A)(B)2V1B(W)(S)(T)(B)
Daikin room air conditioner
4P518786-1F – 2020.05
8.1.6 Symptom: A clapping sound is heard
This sound is generated when an external device sucks air out of the room (e.g.
exhaust fan, extractor hood) while the doors and windows in the room are closed.
Open the doors or windows, or turn off the device.
8.1.7 Symptom: White mist comes out of a unit (Indoor unit, outdoor unit)
When the system is changed over to heating operation after defrost operation.
Moisture generated by defrost becomes steam and is exhausted.
8.1.8 Symptom: The units can give off odours
The unit can absorb the smell of rooms, furniture, cigarettes, etc., and then emit it
again.
8.1.9 Symptom: The outdoor fan rotates while the air conditioner is not in operation
▪ After operation has stopped. The outdoor fan continues to rotate for another
30 seconds for system protection.
▪ While the air conditioner is not in operation. When the outdoor temperature is
very high, the outdoor fan starts to rotate for system protection.
8.2 Solving problems based on error codes
If the unit runs into a problem, the user interface displays an error code. It is
important to understand the problem and to take measures before resetting an
error code. This should be done by a licensed installer or by your local dealer.
This chapter gives you an overview of all possible error codes and their descriptions
as they appear on the user interface.
For detailed troubleshooting of each error, see the service manual.
Fault diagnosis by user interface
The user interface can receive an error code from the indoor unit referring to the
fault. It is important to understand the problem and take measures before
resetting the error code. This should be done by a licensed installer or your local
dealer.
To see the error code on the user interface:
1 Hold for about 5 seconds.
Result: blinks in the temperature display section.
2 Press repeatedly until a continuous beep is heard.
Result: The code is now displayed on the display.
INFORMATION
▪
A short beep and 2 consecutive beeps indicate non-corresponding codes.
▪
To cancel the code display, hold the cancel button for 5 seconds. The
code will also disappear from the display if the button is NOT pressed within
1 minute.