24
10.2
Dry operation
Preparation
• For mechanical protection purpose, turn on the power to the air conditioner at least 6 hours before
starting the operation.
• Dry mode may not to be selected, if the remote controller has no eligibility to select Cooling/Heating
mode (Refer to page 26 for details).
Operation
1
•
Press the Mode Selector button (
) several
times until Dry mode is selected.
Dry mode may not be available depending on
the type of indoor unit.
2
• Press ON/OFF button (
).
The operation lamp (green) will be lit and the air
conditioner will start operating.
The air conditioner controls temperature and
airflow rate automatically. Therefore, the
temperature or airflow rate settings are not
available while the air conditioner is in
operation.
3
• When ON/OFF button ( ) is pressed again, the
air conditioner will stop operating and the
operation lamp will be turned off.
Note:
• To prevent water leakage or system failure, do not turn off the
power immediately. Wait at least 5 minutes for the drain pump to
finish draining residual water from the indoor unit.
01_EN_4P543053-1C.indd 24
10-May-19 4:13:28 PM
