Daikin Altherma EPGA011-016DV, Руководство по установке для специалистов, Страница: 31 / 104

7 Installation
Installer reference guide
31
EPGA11~ EABH/9W
Daikin Altherma – Low temperature split
4P556069-1 – 2018.10
42 kg
3 Attach the unit to the wall bracket:
▪ Tilt the top of the unit against the wall at the position of the
wall bracket.
▪ Slide the bracket on the back of the unit over the wall
bracket. Make sure the unit is fixed properly.
4 Optional: If you want to fix the unit to the wall from inside the
unit:
▪ Remove the upper front panel, and open the switch box. See
"7.2.3 To open the indoor unit" on page 28 .
▪ Fix the unit to the wall with an Ø8 mm screw.
7.4.4 To connect the drain hose to the drain
Water coming from the pressure relief valve is collected in the drain
pan. You must connect the drain pan to an appropriate drain
according to the applicable legislation.
1 Connect a drain tube (field supply) to the drain pan connector
as follows:
a
a Drain pan connector
It is recommended to use a tundish to collect the water.
7.5 Connecting the water piping
7.5.1 About connecting the water piping
Before connecting the water piping
Make sure the outdoor and indoor unit are mounted.
Typical workflow
Connecting the water piping typically consists of the following
stages:
1 Connecting the water piping to the outdoor unit.
2 Connecting the drain hose to the drain.
3 Filling the water circuit.
4 Filling the domestic hot water tank.
5 Insulating the water piping.
7.5.2 Precautions when connecting the water
piping
INFORMATION
Also read the precautions and requirements in the
following chapters:
▪ General safety precautions
▪ Preparation