Daikin Altherma 3 WS, Руководство по установке для специалистов

Страница: 212 / 260

12 | Commissioning
Installer reference guide
212
EWSAH/X06D
Daikin Altherma 3 WS
4P675764-1 – 2022.04
5 Select
OK
to confirm.
Result: The air purge starts. It stops automatically when done.
6 To stop the air purge manually: —
1 In the menu, go to Stop air purge .
2 Select OK to confirm.
12.4.2 Air purge on the central water loop circuit
Install the air-purge (field supplied) on top of the unit and at the highest point on
the return pipe of the central water loop circuit inside the apartment or residence.
Follow the instructions that are included with the air purge system.
12.4.3 To perform an operation test run
Conditions: Make sure all operation is disabled. Go to [C]:
Operation
and turn off
Room , Space heating/cooling and Tank operation.
1 Set the user permission level to Installer . See "To change
the user permission level" [
4
134].
—
2 Go to [A.1]: Commissioning > Operation test run .
3 Select a test from the list. Example: Heating .
4 Select OK to confirm.
Result: The test run starts. It stops automatically when ready
(±30 min).
To stop the test run manually: —
1 In the menu, go to
Stop test run
.
2 Select OK to confirm.
INFORMATION
If the outdoor temperature is outside the range of operation, the unit may NOT
operate or may NOT deliver the required capacity.
To monitor leaving water and tank temperatures
During test run, the correct operation of the unit can be checked by monitoring its
leaving water temperature (heating/cooling mode) and tank temperature
(domestic hot water mode).
To monitor the temperatures:
1 In the menu, go to
Sensors
.
2 Select the temperature information.
12.4.4 To perform an actuator test run
Purpose
Perform an actuator test run to confirm the operation of the different actuators.
For example, when you select
Pump , a test run of the pump will start.
Conditions: Make sure all operation is disabled. Go to [C]:
Operation
and turn off
Room , Space heating/cooling and Tank operation.