Daikin AHT KALEA GM FR, Руководство по эксплуатации

Страница: 43 / 84

AHT Cooling Systems GmbH | en Transport and storage | 6
417632_2_0820 43 / 84
Error
code
Meaning Meaning (EN)
Battery defective Battery defective
Software class B Class B software
EEPROM (control
board defective)
EEPROM (controller
defective)
Goods area temper-
ature too high
High cabinet temper-
ature
Goods area temper-
ature too low
Low cabinet temper-
ature
Control temperature
too low
Low control temper-
ature
Control temperature
too high
High control temper-
ature
Defrosting time-out
Defrost terminated
by time
SD memory card de-
fective
SD card defective
Bus alarm Bus alarm
Invalid configuration Invalid Configuration
Acknowledge alarm
Acknowledge acous-
tic alarm
Press .
Error code CANNOT be acknowledged.
The error code is displayed until the error is rectified.
6 Transport and storage
a) After delivery, check the appliance for transport
damage.
b) In the event of damage to the appliance, promptly
contact the maintenance service
[see
}
Chapter 12.5] .
WARNING
Damage to the refrigerant circuit.
Flammable refrigerant can escape and cause
an explosive gas/air mixture.
§
Do not expose the appliance to temperat-
ures higher than 70°C (158°F) during
transport and storage.
§
Ensure good ventilation.
§ Observe safety notices and warnings for
appliances with flammable refrigerants
[see
}
Chapter 2.5.2] .
§
In the event of damage to the appliance,
promptly contact the maintenance service
[see
}
Chapter 12.5] .
Loss of stability of the appliance due
to material damage
.
Appliance tipping hazard. Persons may be-
come trapped
.
§
Do not expose the appliance to temperat-
ures higher than 70°C (158°F) during
transport and storage.
Transport of the appliances with indus-
trial trucks.
Risk of injury to persons in the event of a colli-
sion.
§
Observe transport routes for industrial
trucks.
§
Secure transported goods.
§
Only trained personnel may operate in-
dustrial trucks.
§ Note the centre of gravity of the appliance
for safe lifting of the load with the forklift.
Information is provided on the front and
back of the appliance packaging.
NOTICE
Material damage caused by transport and
storage.
§ Transport and store the appliance in a stable oper-
ating position (horizontal alignment).
§
If the unit was tilted during transport, wait at least
two hours before starting it up.
§
On delivery, ensure full accessibility to the installa-
tion point (observe clearance heights, clearance
widths, installation space height, sufficient turning
radii).
§ Do not store the appliance outdoors.
§
Only AHT installation service may remove of fit the
transport frame supporting the appliance.
§
Only qualified staff may move the appliance
without the transport frame.
7 Unpacking
Responsibility
– Qualified staff
a) Check the appliance for damage before and during
unpacking.
b) In the event of damage to the appliance, promptly
contact the maintenance service
[see
}
Chapter 12.5] .
WARNING
Dispose of packaging material and
film.
Suffocation hazard.
§
Keep packaging material and film away
from children.
§ Do not allow children to play with pack-
aging material or film.