Daihen OTC Welbee WB-M350, Руководство пользователя

Страница: 63 / 144

6-1
Chapter 6 W
elding Condition
Chapter 6 Welding Condition
This chapter explains the functions on the operation panel as well as how to set the welding conditions.
6.1 List of Welding Conditions
This section explains the parameters/functions settable in the welding power source.
6.1.1 Parameter (Welding parameter)
6.1.2 Function
Parameter
Set Range
Initial
Value
Descriptions
Three phase Single phase
Pre-flow time 0 to 10 sec 0.1 sec
Set the gas discharge time before
welding starts.
Initialized
condition/
Main condition/
Crater condition
Current
20 to 400 A
10 to 400 A
(for TIG welding)
20 to 300 A
(for DC STICK welding)
20 to 250 A
10 to 250 A
(for TIG welding)
20 to 250 A
(for DC STICK welding)
150 A Initial Condition: set the current and
voltage value soon after the welding.
Welding condition: set the current
and voltage value during the welding.
Crater condition: set the current and
voltage value at the end of welding.
Voltage
(INDIVIDUAL)
12.0 to 38.0 V 12.0 to 34.0 V 19.0 V
Voltage
(SYNERGY)
-100 to 100 0
Post-flow time 0 to 10 sec 0.4 sec
Set the gas discharge time after the
welding ends.
Arc spot time 0.1 to 10 sec 3 sec Set the welding time at arc spot.
Arc characteristics -99 to 99 0
Set the arc to the condition from soft
to hard.
Welding condition memory No. 1 to 100 1
Register the welding conditions
(storable up to 100).
Function Initial value Setting parameter
CRATER-FILL CRATER-FILL-OFF CRATER-FILL-OFF / CRATER-FILL-ON / CRATER-FILL-ON (REPEATED) / ARC SPOT
GAS
MAG (20 ％ CO
2
) MAG (20 ％ CO
2
) / MIG (2 ％ O
2
) / MIG (100 ％ Ar)
WIRE
MATERIALS
MILD STEEL
MILD STEEL / MILD STEEL CORED / STAINLESS STEEL / STAINLESS CORED /
SOFT ALUMINUM / HARD ALUMINUM
WELDING
METHOD
DC DC / DC TIG / DC STICK
WIRE DIA.
[in.(mm)]
.045 (1.2) .030 / .035 / .040 / .045 / .052 / 1/16 (0.8/0.9/1.0/1.2/1.4/1.6)
INITIAL
CONDITION
OFF ON/OFF
VOLT. ADJUST INDIV. SYNERG. / INDIV.
CONSTANT
PENETRATION
OFF ON/OFF